It must be connected before starting the oil pipes, so that spindle connected to the spindle motor oil pipe before start, when installing water pipe can not be wrong. Spindle left and right sides of the water, in the middle of the tubing (CNC milling machine spindle grease lubricated, do not use the above method.)
2. Using electric spindle should first contact point lubricator tube, pipe joints should be clean and clear point, to prevent dirt from entering the bearing caused by burn. Operation should look after the front end portion of the electro-spindle slight mist escape, to start the spindle, oil mist lubrication is recommended No. 5 spindle oil regulator, inlet pipe 20 to 30 drops / min, always check the oil can not be broken, otherwise it will damage caused by the spindle.
3. When operating, the spindle must be done after a complete stop before they closed mist, so as to extend the service life, indicating that it should not start frequently.
4. Power must be checked before using the wheel spindle lever is connected coaxially, such as different axes more than 0.03 mm should also Grinding Wheel Pole, otherwise damage to both the spindle, and wear good work, grinding should be careful not to bump should be corrected then go grinding.